Maytag Error Codes: What They Mean and What To Do

Maytag logo

Find your code below for what it means, what you can safely try, and when to book a repair. Codes vary by model, and your owner's manual is the final reference.

Reviewed by Ronen Itzkovitch, owner and certified Appliance Service Technician. Codes taken from Maytag's official support pages, last verified November 18, 2026.

Maytag refrigerator codes

More help: Refrigerator repair in Toronto · Maytag refrigerator repair

Power outage — the freezer warmed up while the power was off.

Common causes

  • Power cut

What you can safely try

  • Check food for thawing
  • Press the alarm button to clear it

When to call: Not a fault — no service needed unless it keeps happening.

Varies by model — check your owner's manual.

The control has found a fault.

Common causes

  • Sensor or control issue

What you can safely try

  • Switch off the breaker or unplug for one minute, then restore power
  • Make sure cooling is switched on

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Varies by model — check your owner's manual.

Cooling has been switched off — the lights work but nothing gets cold.

Common causes

  • Cooling turned off from the panel

What you can safely try

  • On many models, hold Lock and Measured Fill together for 3 seconds to turn cooling back on

When to call: Not a fault — no service needed unless it keeps happening.

Varies by model — check your owner's manual.

Maytag washer codes

More help: Washer repair in Toronto · Maytag washer repair

Also shown as: LO FL, LF

Low water flow — the washer isn't getting enough water.

Common causes

  • Taps not fully open
  • Kinked inlet hose

What you can safely try

  • Open both taps fully
  • Straighten the hoses

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Varies by model — check your owner's manual.

Also shown as: drn

Draining takes longer than about 8 minutes.

Common causes

  • Kinked or clogged drain hose
  • Drain hose pushed too far into the standpipe

What you can safely try

  • Check the drain hose for kinks

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Varies by model — check your owner's manual.

Door isn't locking properly.

Common causes

  • Laundry blocking the door

What you can safely try

  • Clear the door and close it fully
  • Press Pause/Cancel twice and Power once to clear it

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Varies by model — check your owner's manual.

Motor can't reach the right speed.

Common causes

  • Shipping bolts left in
  • Washer overloaded

What you can safely try

  • Make sure the shipping bolts are out
  • Take some laundry out

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Varies by model — check your owner's manual.

Also shown as: Sd

Too many suds.

Common causes

  • Too much or non-HE detergent

What you can safely try

  • Let the washer finish its extra rinse
  • Use less HE detergent next time

When to call: Not a fault — no service needed unless it keeps happening.

Varies by model — check your owner's manual.

Lid won't lock.

Common causes

  • Something under the lid
  • Detergent buildup around the lid lock

What you can safely try

  • Check for items under the lid
  • Wipe around the lock

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Top-load washers.

Load is out of balance.

Common causes

  • Laundry bunched to one side

What you can safely try

  • Spread the load out, close the lid and restart

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Top-load washers.

Maytag dryer codes

More help: Dryer repair in Toronto · Maytag dryer repair

Also shown as: F4 E3

Restricted airflow — lint screen or vent is clogged.

Common causes

  • Full lint screen
  • Crushed, kinked or long vent

What you can safely try

  • Clean the lint screen
  • Check the vent outside opens freely

When to call: Book service if the code stays once the vent is clear.

Varies by model — check your owner's manual.

Low or no line voltage — the heater may not turn on.

Common causes

  • Breaker tripped
  • Home power supply issue

What you can safely try

  • Check both dryer breakers

When to call: Book service if the breakers are fine.

Varies by model — check your owner's manual.

A power failure interrupted the cycle.

Common causes

  • Power cut

What you can safely try

  • Press and hold Start to restart

When to call: Not a fault — no service needed unless it keeps happening.

Varies by model — check your owner's manual.

The control found a problem that needs service.

What you can safely try

    When to call: This one needs a technician. Please don't open panels yourself.

    Varies by model — check your owner's manual.

    Maytag dishwasher codes

    More help: Dishwasher repair in Toronto · Maytag dishwasher repair

    Long drain — water isn't draining.

    Common causes

    • Dirty filter
    • Kinked drain hose
    • Disposer plug not removed

    What you can safely try

    • Clean the filter
    • Check the drain hose under the sink
    • Run the disposer

    When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

    Varies by model — check your owner's manual.

    Water detected in the drip tray.

    Common causes

    • Leak inside the cabinet

    What you can safely try

    • Turn off the water and power

    When to call: This one needs a technician. Please don't open panels yourself.

    Varies by model — check your owner's manual.

    Wash motor fault.

    Common causes

    • Motor or wiring problem

    What you can safely try

    • Switch off power for a minute and restart

    When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

    Varies by model — check your owner's manual.

    Also shown as: H20

    Not detecting water.

    Common causes

    • Water supply turned off
    • Kinked supply hose

    What you can safely try

    • Make sure the water supply is on
    • Check the hose for kinks

    When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

    Varies by model — check your owner's manual.

    Maytag range & oven codes

    More help: Range & oven repair in Toronto · Maytag range & oven repair

    Also shown as: F9 E0

    Outlet or power connection may be miswired.

    Common causes

    • Wiring problem, often after a new install

    What you can safely try

      When to call: If it was installed recently, have an electrician check the outlet. Otherwise book service.

      Varies by model — check your owner's manual.

      There was a power failure.

      Common causes

      • Power cut

      What you can safely try

      • Press Cancel and reset the clock

      When to call: Not a fault — no service needed unless it keeps happening.

      Varies by model — check your owner's manual.

      Also shown as: Lock, Locked

      Control lock is on.

      What you can safely try

      • See your manual to unlock the controls

      When to call: Not a fault — no service needed unless it keeps happening.

      Varies by model — check your owner's manual.

      Also shown as: 5AB

      Sabbath mode is on.

      What you can safely try

      • See your manual to turn Sabbath mode off

      When to call: Not a fault — no service needed unless it keeps happening.

      Varies by model — check your owner's manual.

      Contact us

      Book Your In-Home Appliance Service Visit

      Call us to book a home visit, or place a home service request online and we'll get back to you to confirm a time.

      Call us to book a home visit

      (647) 308-8103

      Sunday to Friday, 9 am – 7 pm

      Call now

      Fields marked * are required.

      Photos (optional, up to 5)

      A photo of the appliance, its model label or any error code helps us come prepared.

      Total Care Appliance Repair is an independent service company and is not affiliated with or authorized by Maytag. Brand names are used only to describe the appliances we repair.