Whirlpool Error Codes: What They Mean and What To Do

Whirlpool logo

Find your code below for what it means, what you can safely try, and when to book a repair. Codes vary by model, and your owner's manual is the final reference.

Reviewed by Ronen Itzkovitch, owner and certified Appliance Service Technician. Codes taken from Whirlpool's official support pages; codes marked * aren't published by Whirlpool and come from reliable repair references, last verified November 18, 2026.

Whirlpool refrigerator codes

More help: Refrigerator repair in Toronto · Whirlpool refrigerator repair

Power outage — the freezer warmed to -8°C (18°F) or higher while the power was off.

Common causes

  • Power cut

What you can safely try

  • Check food for thawing
  • Press the alarm button to clear it

When to call: Not a fault — no service needed unless it keeps happening.

Varies by model — check your owner's manual.

The control has found a fault.

Common causes

  • Control or sensor issue

What you can safely try

  • Switch off the breaker or unplug for one minute, then restore power

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Varies by model — check your owner's manual.

Whirlpool washer codes

More help: Washer repair in Toronto · Whirlpool washer repair

Also shown as: LO FL, LF

Low water flow — the washer isn't getting enough water.

Common causes

  • Taps not fully open
  • Kinked inlet hose
  • Clogged inlet screen

What you can safely try

  • Open both taps fully
  • Straighten the hoses

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Varies by model — check your owner's manual.

Draining takes longer than about 8 minutes.

Common causes

  • Kinked or clogged drain hose
  • Drain hose pushed too far into the standpipe

What you can safely try

  • Check the drain hose for kinks
  • Clean the drain pump filter if your model has one

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Varies by model — check your owner's manual.

Door isn't locking properly.

Common causes

  • Laundry blocking the door

What you can safely try

  • Clear the door and close it fully
  • Press Pause/Cancel twice and Power once to clear it

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Varies by model — check your owner's manual.

Motor can't reach the right speed.

Common causes

  • Shipping bolts left in
  • Washer overloaded

What you can safely try

  • Make sure the shipping bolts are out
  • Take some laundry out

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Varies by model — check your owner's manual.

Also shown as: Sd

Too many suds.

Common causes

  • Too much or non-HE detergent
  • Restricted drain hose

What you can safely try

  • Let the washer finish its extra rinse
  • Use less HE detergent next time

When to call: Not a fault — no service needed unless it keeps happening.

Varies by model — check your owner's manual.

Lid won't lock.

Common causes

  • Something under the lid
  • Detergent buildup around the lid lock

What you can safely try

  • Check for items under the lid
  • Wipe around the lock

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Top-load HE washers.

Load is out of balance.

Common causes

  • Laundry bunched to one side

What you can safely try

  • Spread the load out, close the lid and restart

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Top-load HE washers.

Also shown as: F02

Long drain — water is taking too long to leave the washer.

Also seen on Whirlpool Duet

Common causes

  • Kinked or blocked drain hose
  • Blocked drain filter
  • Too many suds

What you can safely try

  • Check the drain hose for kinks
  • Use only HE detergent
  • Clean the drain filter only if your owner's manual describes an accessible filter

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Compatible older Duet/front-load models. F21 and F02 are different displays used by different models; check your manual.

The control isn't getting the expected signal from the motor's rotor position sensor.

Also seen on Whirlpool Cabrio

Common causes

  • Sensor or wiring problem
  • Basket movement restricted

What you can safely try

  • Remove some laundry and retry; don't force the basket or open panels

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Older Cabrio top-load models using this code, including WTW6800WW1; not all Cabrio washers.

* Not published by the manufacturer. Summarized from AppliancePartsPros; check your owner's manual or tech sheet.

An overload or restricted basket movement has been detected.

Also seen on Whirlpool Cabrio

Common causes

  • Too much laundry
  • Basket unable to move as expected

What you can safely try

  • Remove some laundry and restart the cycle

When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

Older Cabrio top-load models using this code, including WTW6800WW1. This is not the meaning of F70 on a dryer.

* Not published by the manufacturer. Summarized from AppliancePartsPros; check your owner's manual or tech sheet.

The basket hasn't re-engaged as expected after draining.

Also seen on Whirlpool Cabrio

Common causes

  • Basket movement restricted
  • Drive mechanism problem

What you can safely try

  • Stop the cycle; don't force the basket or remove panels

When to call: This one needs a technician. Please don't open panels yourself.

Only older top-load models whose own tech sheet lists F72 as basket re-engagement failure. The reference excerpt doesn't identify the complete model range.

* Not published by the manufacturer. Summarized from AppliancePartsPros technical-document excerpt; check your owner's manual or tech sheet.

Whirlpool dryer codes

More help: Dryer repair in Toronto · Whirlpool dryer repair

Also shown as: F4 E3

Restricted airflow — lint screen or vent is clogged.

Common causes

  • Full lint screen
  • Crushed, kinked or long vent

What you can safely try

  • Clean the lint screen
  • Check the vent outside opens freely
  • Have the vent cleaned

When to call: Book service if the code stays once the vent is clear.

Varies by model — check your owner's manual.

Low or no line voltage — the heater may not turn on.

Common causes

  • Breaker tripped
  • Home power supply issue

What you can safely try

  • Check both dryer breakers

When to call: Book service if the breakers are fine.

Electric models.

Power failure interrupted the cycle.

Common causes

  • Power cut

What you can safely try

  • Press and hold Start to restart

When to call: Not a fault — no service needed unless it keeps happening.

Varies by model — check your owner's manual.

The control found a problem that needs service.

What you can safely try

    When to call: This one needs a technician. Please don't open panels yourself.

    Varies by model — check your owner's manual.

    Whirlpool dishwasher codes

    More help: Dishwasher repair in Toronto · Whirlpool dishwasher repair

    Long drain — water isn't draining.

    Common causes

    • Dirty filter
    • Kinked drain hose
    • Disposer plug not removed

    What you can safely try

    • Clean the filter
    • Check the drain hose under the sink
    • Run the disposer

    When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

    Varies by model — check your owner's manual.

    Water detected in the drip tray.

    Common causes

    • Leak inside the cabinet

    What you can safely try

    • Turn off the water and power

    When to call: This one needs a technician. Please don't open panels yourself.

    Varies by model — check your owner's manual.

    Wash motor fault.

    Common causes

    • Motor or wiring problem

    What you can safely try

    • Switch off power for a minute and restart

    When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

    Varies by model — check your owner's manual.

    Control panel / main control fault.

    Common causes

    • Control problem

    What you can safely try

    • Switch off power for a minute and restart

    When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

    Varies by model — check your owner's manual.

    Whirlpool range & oven codes

    More help: Range & oven repair in Toronto · Whirlpool range & oven repair

    Control panel or keypad problem.

    Common causes

    • Grates sitting unlevel on some models
    • Keypad or wiring issue

    What you can safely try

    • Make sure the grates sit flat
    • Switch off the breaker for one minute

    When to call: Book service if the code returns after the safe step, or if the appliance is not working normally.

    Varies by model — check your owner's manual.

    Also shown as: F9 E0

    Outlet or power connection may be miswired.

    Common causes

    • Wiring problem, often after a new install

    What you can safely try

      When to call: If it was installed recently, have an electrician check the outlet. Otherwise book service.

      Varies by model — check your owner's manual.

      There was a power failure.

      Common causes

      • Power cut

      What you can safely try

      • Press Cancel and reset the clock

      When to call: Not a fault — no service needed unless it keeps happening.

      Varies by model — check your owner's manual.

      Also shown as: 5AB

      Sabbath mode is on.

      What you can safely try

      • See your manual to turn Sabbath mode off

      When to call: Not a fault — no service needed unless it keeps happening.

      Varies by model — check your owner's manual.

      Contact us

      Book Your In-Home Appliance Service Visit

      Call us to book a home visit, or place a home service request online and we'll get back to you to confirm a time.

      Call us to book a home visit

      (647) 308-8103

      Sunday to Friday, 9 am – 7 pm

      Call now

      Fields marked * are required.

      Photos (optional, up to 5)

      A photo of the appliance, its model label or any error code helps us come prepared.

      Total Care Appliance Repair is an independent service company and is not affiliated with or authorized by Whirlpool. Brand names are used only to describe the appliances we repair.